So what's the trick to putting a port in the pommel? My speaker covers the opening, so no room to feed wires from port to hilt. Im doubtful drilling holes through speaker is answer.
So what's the trick to putting a port in the pommel? My speaker covers the opening, so no room to feed wires from port to hilt. Im doubtful drilling holes through speaker is answer.
The typical method is to cut a small channel in the outside of your speaker holder, and run your wires through that. The wires will go around the speaker, not through it.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
There is generally enough clearance to cut a channel on the side of the speaker holder, to run the wires past the speaker.
Bookmarks