Wiring Diagram

[Tymtrppr3]

I have completed my wiring Diagram. The battery is a 3.7V Panasonic NCR 18650b button top protected cell.
I dont expect you to check my resistor calculations, other than there is a resistor there. I just want to double check and make sure that this is the correct wiring setup for this saber, as I am a first time builder. Thanks again NB3 ASP Saber.jpg

[Generic Jedi]

Your diagram mostly looks good to me.

You won't need the DynaOhm resistor, unless you have one of the light up AV switchs. If so, you wouldn't use the DynaOhm where you have it in the diagram.

At 3.7 volts, the RedOrange LEDs need 1.2 Ohm resistors, not 1.2K Ohm resistors.

[Tymtrppr3]

Thanks for double checking. that was my bad, not sure why I put the K. Also, where would you hookup the resistor for the switch then? It will be an illuminated switch.

[Tymtrppr3]

Gotcha, i completely forgot about adding the positive and negatives for the LED posts on the switch. so it would go on the LED wire of the AV Switch.

[Generic Jedi]

That's right. The DynaOhm must go on the positive wire to the switch LED. It also has a voltage in and a voltage out that you'll want to pay attention to when you wire it up.

[Darth Shizzle]

Should the ground lead from the switch LED go to the SWITCH terminal on the card or the POWER NEG on the card, or would it matter?

[Generic Jedi]

Power Negative.