Dcls-005

**ls-event** · 06-13-2017, 10:44 AM

Originally Posted by darth_chasm

[/URL]

Haha, I know where that piece came from. Was thinking about using some pieces from the Millennium Falcon for a crystal chamber. Tie fighter ended up being built.

**darth_chasm** · 06-13-2017, 10:55 AM

Originally Posted by ls-event

Haha, I know where that piece came from. Was thinking about using some pieces from the Millennium Falcon for a crystal chamber. Tie fighter ended up being built.

You gotta keep it on lock down when you uncover a secret source of awesome pieces. Sheesh

**rlobrecht** · 06-13-2017, 12:13 PM

Fantastic looking.

**darth_chasm** · 06-18-2017, 02:15 PM

Testing out some SMDs, the blade and the crystal led. The crystal was too lime-y so I've since color mixed an RGB with resistors to get it right.

**darth_chasm** · 07-08-2017, 04:40 PM

By the way... screw photobucket

**Jenny** · 07-08-2017, 06:39 PM

Very nice! I like the copper and brass pieces next to each other. Nice contrasts.

And yes; Photobucket is being a pain lately. I use Cloudinary.

**Whosle** · 07-09-2017, 08:21 AM

Even if someone revealed one of your greeble sources, the skill required to make a chamber that detailed is amazing!

So convincing! Another awesome DC saber .

All those little bits in there , and not a drop of solder or glue to be seen. Are you a surgeon and watchmaker?

**Tom Tilmon** · 07-09-2017, 11:09 AM

Darth Chasm said, "By the way... screw photobucket'

Hahahaha! Yep, absolutely screw them. They messed up a lot of stuff, I hope they absolutely collapse after this move. May the burn in the eternal pits of Mustafar!

Tom

**darth_chasm** · 07-09-2017, 03:20 PM

Originally Posted by Whosle

Even if someone revealed one of your greeble sources, the skill required to make a chamber that detailed is amazing!

So convincing! Another awesome DC saber .

All those little bits in there , and not a drop of solder or glue to be seen. Are you a surgeon and watchmaker?

Ha, neither of those I'm afraid. I actually have revealed some sources over on FX Sabers. It should be stickied in the saber mods and customs board. The top and bottom bases were designed and 3D printed. A lot of other little thing I make by hand.