Ok so I'm new to all this, but I have put in a good couple of weeks looking a lot at the same pages in the shop. And looking around on here. But to cut long story short, I have a nephew I want to build him one of his designed lightsaber a, but firstly I want to build a crystal chamber and chassis to go on the inside. The plan is to have an ID of the hilt to be 1" and OD of 1.25". But I would like to build a chamber and chassis to slide inside it. All the individual parts that make up the chassis/inside of the hilt, I just look at and have no idea. So I looked at MWS to help break me into it. Is this a possible better way to get into the whole electronical side of the build?

I have a whole load of questions about each bit. But firstly, it would be good to know if this is the best approach to start with.