Hey guys, Greg here and yeah, i am about to build my first saber and i am a little confused about the resistors...
I am using a NBV3 and a 18650 3.7V aswell as a Tri Cree RRW. So first, my question i found a lot of different opinions abou this, but in the end i couldn't get smart out of it. So: should i wire the two red leds with one resistor? Because now, I came out with 1.11 ohm 1.11 watt for 1 red equals rounded up: 2x 1.2 ohm and 2/3 watt resistors. And now for the white FoC led: 0.55 ohm and watt equals: now another question should I round up to 0.6 ohm 1w/2w or 1 ohm 1w. Thank you for your advice.
Greg
Bookmarks