Hey guys,

I wanna check if this is correct- I've successfully built this build before with the exception of the recharge port.

I want to check if I'm doing it correctly because after wiring it up -upon saber performing anything other than activation and deactivation my motor surges and the saber stops functioning.
I then replace the kill key in saber and remove it for successful boot and ignition


Specs-
CF 8
7.4 volt TCSS battery pack
RB,G,A tri cree led
recharge port
motor(can't recall voltage-currently working on another saber tho-same motor and set up)
2 accent led(currently-wanna add bar graph once this is sorted-I do have all the smd resistors soldered to board currently)
IMG_0306.jpg
IMG_0307.jpg
boardia.jpg
I included pictures of the connection to board from motor-Maybe my soldering for the motor lead is bad to the board
Anyone know any tests or suggestions for finding a solution?

I appreciate the help.