Results 1 to 2 of 2

Thread: Wiring Check for NBv2

  1. #1

    Default Wiring Check for NBv2

    Hey Guys, I took a short hiatus from sabers but I started building some for the upcoming Christmas season. The first was a stunt saber, simple battery, switch, buck puck, and LED. But the other one will be a full saber. It's got a NBv2, single LED for the blade, and an accent LED AV Switch. I wired up the bulk of it, still need to add a resistor to the main LED, but when I tried to do a test to hear that sweet sweet hum and NADA came of it. Was hoping you guys could give it a look and tell me where I went wrong. I really hope I didn't fry my board. Thanks for the help in advance.
    NBv2 Wire Check.jpg
    Attached Images Attached Images

  2. #2

    Default

    Hey Guys, I just wanted to thank everyone who took a look at my problems. After messing around with it for a bit I discovered it works so much better with the SD card installed. Now I just need to get the LED resistor set up and I'm in business.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •