Will this wiring work for AV Switch (No Sound)?
The neutral light calls to me.
I would change the LED (+) wire so that it connects to the red wire on the right side of the switch. The current setup will work, but the switch LED will be on all the time and it'll constantly drain your battery.
Be sure you have a latching AV switch, or you'll need to hold the switch down to keep the saber on.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Would this make it so the AV switch's LED would turn on only when I activate it?
AVSwitch2.jpg
Yes, I have the latching version.
The neutral light calls to me.
Looks right to me.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Thank you very much!
The neutral light calls to me.
Posting Permissions
Reply With Quote
Bookmarks