The first 3 build concepts

[Madwolf]

The first will be called Honor.

The section before the crystal chamber will be heavily etched/engraved and the section behind the crystal chamber will be wrapped in cord or leather.

The second will be called Duty.

Same as above.

The third will be a saber for my wife. I intend for it to be separated, but when together I want it to be activated by either switch.

Etched/engraved from emitter to switch hole on both ends and then wrapped to the center chamber.

I intended to use a Nano Biscotte in each build (two in the double saber) and Tri Cree LEDs. I'm designing the chassis for Honor now. I have been researching custom lightsabers for about the last year and finally decided to go the build your own route after being led to the Custom Saber Shop by a few posts on the Rebel Legion forums. I can't see spending a large amount of cash on a saber that might not work based on reports on this site's competitors. So I've been watching videos and lurking in the forums. More to come as I draw out the scale chassis design and finalize the intended wiring.

Madwolf

[MasterStoddard]

I like the first hilt for its length.