Results 1 to 5 of 5

Thread: Roque Sound Font, clicking noise?

  1. #1

    Default Roque Sound Font, clicking noise?

    So, I purchased the Roque font.
    Itīs awesome to say the least.

    I did what I always do, since Iīm not packing a CF.
    Selected the swings, clashes, power on/off that I wanted.

    The volume was quite low on this font, so I decided to up the volume in Audacity, as I always do with fonts.
    Now after a clash or swing, thereīs a clicking noise when returning to the hum.
    I tried everything I could think of, but no luck.

    If I just load the original volume on the font, it sounds fine.

    Any ideas?

    Btw, the board is a Nano Biscotte V3 with 28mm bass speaker from tcss.

  2. #2


    Sounds like the font is clipping when you run it through Audacity. Watch your peaks.

  3. #3


    Also when you save, clear the metadata.

  4. #4


    Thanks guys, will try again.
    Good input!

  5. #5


    Whenever you change the volume of a sound file you risk altering a number of things. Perhaps the zero crossings at the beginning and end of each file get altered. I would check those too.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts