Results 1 to 6 of 6

Thread: can you guys check out my diagram

  1. #1

    Default can you guys check out my diagram

    diagram.jpg

    can you guys tell me how this looks?

  2. #2

  3. #3

    Default

    so its okay to have 2 wires conected to 1 pad? cause in the manule diagram it looks like a wire branches of from another wire? likethey just attached a wire 2 a middle of another wire wich looks more difficult and impractical.

  4. #4

    Default

    It's typically easier to attach a single wire to a pad, and do a splice further down. Both ways are correct, but it can be tricky for a novice to connect two wires to a single pad at the same time.

    If you twist the ends of the two wires together and pretin them as a single unit, it isn't so hard to connect them to the pad.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

  5. #5

  6. #6

    Default

    Can also try to solder the second wire on the underside of the board. Should be a pad there, too.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •