Wiring a PLI on CF8

[Scarecrow]

I'm adding an 8 segment bargraph to a CF8 for use as a PLI. My understanding is that all LED's will be lit at maximum voltage. As voltage decreases, LED's will turn off until only one remains. Here's the question: Is accent pad 1 the high side or low side? Meaning, should the greens be on pads 1-2 or 7-8 if they indicate max voltage? Apologies if this has been addressed already, I just couldn't find it. Thanks!

[Madcow]

I'm adding an 8 segment bargraph to a CF8 for use as a PLI. My understanding is that all LED's will be lit at maximum voltage. As voltage decreases, LED's will turn off until only one remains. Here's the question: Is accent pad 1 the high side or low side? Meaning, should the greens be on pads 1-2 or 7-8 if they indicate max voltage? Apologies if this has been addressed already, I just couldn't find it. Thanks!

LED 1 is the low side, LED 8 is the high/full side.

[Scarecrow]

Thank you so much!