I had planned to use a MWS buckpuck, but ...

[Atilla]

Hey, everyone.

A few months ago, I stumbled upon a lightsaber combat group at a park walking distance from my house. I made a visit to The Custom Saber Shop armed with more enthusiasm than knowledge; my intent was/is to make a stunt saber with the only nod to fanciness being an illuminated switch. I wound up with a modular LED and Li-ion battery (1050 mah, the 14560), along with a non-modular long anti-vandal latching switch (green, to match the blade). I now have the switch wired with the Dyna-ohm resistor to the positive terminal, and the negative and positive wires connecting to a JST connector ... I left the other three terminals for the moment.

Since the MWS buckpucks have been out of stock for quite awhile, I'm wondering what options I have to wire it to a different buckpuck. I don't have any plans to add sound, though a recharge port might be in the future.

(If this matters, I did pick up materials for making a chassis, too. The discs I ordered are to accommodate a buckpuck and the battery. Oh ... and I know the long AV switches are on the long side, but I have solution to that involving a bit of copper tubing and a 3d-printed bit of plastic.)

Thanks for any thoughts!

[Silver Serpent]

Buckpucks are fine, but you need a minimum of 5v to operate them properly. Is your battery pack a single cell 3.7v pack, or a 7.4v li-ion?

You can always use a resistor in your setup. It's not hard to calculate the value (there are links in my signature), and a resistor is a much less expensive option.

[rlobrecht]

The non-MWS ones are in stock. You could always add your own JST connectors.

[Atilla]

Silver Serpent, it's the 7.4. What I had in mind is what rlobrecht mentioned ... using a non-MWS buckpuck. The thing is, I wasn't sure which one is right for:
1. Using the illuminated switch
2. Allowing for later installation of a recharge port. (Speaking of that, does anyone put their ports down in the pommel? I'm using insert style 10

That MWS buckpuck has a ton of wires coming off of it and, without having one in-hand, I haven't been able to figure out which ones are unnecessary for my purposes. I'm guessing, though, that it's the 6-wire 1000mA; the source of my confusion is the part numbers on that one versus the part number on the MWS buckpuck.

There's also that mention in the long AV switch description about "You will need to jumper the accent LED resistor screw terminals with a piece of wire." Wasn't sure if that meant on the buckpuck or the switch.

Thanks for the replies!

[Silver Serpent]

Either the 4 or 6 wire 'puck will do the job. You have two input wires (pos and neg), and two output wires (pos and neg). In the 6 wire 'puck, the other two are used as a dimmer, typically with a potentiometer or some such.

The accent LED in the AV switch will be wired parallel to your main LED.

[Atilla]

Thanks very much, Serpent. Am I understanding you correctly in this very badly done sketch?

saber wiring_stunt.jpg