How Does This Look?

[bunger]

Read the NB manual. It will literally answer nearly all of your questions (including how to select the appropriate resistors)

http://www.plecterlabs.com/Media/Doc...te%20v3-GB.pdf

[Trow]

Read the NB manual. It will literally answer nearly all of your questions (including how to select the appropriate resistors)

http://www.plecterlabs.com/Media/Doc...te%20v3-GB.pdf

That is super helpful. Thanks! I'm working in a modified list right now.

[Trow]

Ok let's try this.

Body:
Hilt 2
Choke 3
Pommel 4
Emitter 12


Electronics
NB3
Bass speaker
18500 battery
Recharge port
Cree XP-E2 r/r/w
MHS heat sink V3
18 degree Cree lens
16mm momentary AV switch short (gold plated)
I'll need to calculate the resistor values for the LEDs but I'll get the values later.

I put the hilt parts too to make sure it's all compatible.

[Silver Serpent]

Those parts will work fine together. I would advise getting at least one of these: http://www.thecustomsabershop.com/St...-LED-P483.aspx

A second wouldn't be a bad idea, in case you ever need to resolder any of the LED star connections. It's virtually impossible to do while mounted on the heat sink, and those thermal pads are not reusable. Good thing they're inexpensive.