My first Saber- Massacre

[Gal-An Iabos]

hello all- this is my second post and i'd like to formally introduce myself and say hello and offer ym own small contribution to the forums - i wanted to post my first ever saber i built this past October- Massacre- a 12 inch 1 1/4 sinktube and 6 inch 1 1/2 inch sink tube- tcss bladeholder and heatsink and modular wiring system electronics

100_0874.jpg

100_0873.jpg

[Sevinzol]

Welcome to the forums.
Nicely done.

[phook15]

Nice work. How does the 1 1/4 inch tube fit into the 1 1/2 tube? Any wiggle when you swing the blade?

[Gal-An Iabos]

it's prett secure on there- i used a 12 inch 1 1/4 inch slip joint extension tube as the main tube and a 6 inch 1 1/2 inch outer tube. if you slide the larger but over the smaller one you can "clamp" them together with a cheap hole plug and the 1 1/12 inch slip joint and i use a clear polywasher to secure it up top and a black rubber polywasher for astetics