Results 1 to 4 of 4

Thread: Sink Tube - etched dragon

  1. #1

    Default Sink Tube - etched dragon

    A "Sink Tube" saber with Master Replicas sound board running two green Cree XPE2 LED; etched dragon symbol, and a blade retention crew with inset Swarovski crystal.

    TCSS sink tube adapter (ground down to 1.18" OD), #4 pommel, and 1.18" blade holder.

    Em_sink tube.jpg
    So certain are you; always with you it cannot be done.
    Hear you nothing that I say?


    http://www.plecterlabs.com/Media/Doc...deTutorial.pdf
    http://forums.thecustomsabershop.com...Hardware-Saber
    ---------------------

  2. #2
    So certain are you; always with you it cannot be done.
    Hear you nothing that I say?


    http://www.plecterlabs.com/Media/Doc...deTutorial.pdf
    http://forums.thecustomsabershop.com...Hardware-Saber
    ---------------------

  3. #3

    Default

    Looks nice. the etching is a little had to see. The dragon look coppery, I thought most sink tubes were brass.

  4. #4

    Smile

    Quote Originally Posted by Sevinzol View Post
    Looks nice. the etching is a little had to see. The dragon look coppery, I thought most sink tubes were brass.

    Yes, one etches a sink tube by using the saltwater method to strip off rhe chrome plating. So detail can be tough to see in photos, as doing so is not the most precise manner of etching. The brass looks coppery due to slight oxidation. Brass is, after all, a copper alloy.
    So certain are you; always with you it cannot be done.
    Hear you nothing that I say?


    http://www.plecterlabs.com/Media/Doc...deTutorial.pdf
    http://forums.thecustomsabershop.com...Hardware-Saber
    ---------------------

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •