Wiring check; externally driven Lightsaber

[rumlyne]

Hi!

Since the recharge ports are also available in smaller sizes I thought about putting 3 more in the bottom or side of my saber and build a stand with the plugs connected to an external driver. In theory that should decouple the LEDs from the CF/PC (not sure about it) and drive them in series from my pwm driver in the stand. Part time light saber part time lamp .
However I am not an electronics engineer and we only coverd so much electronic basics in school so please look over the wiring diagram and tell me if I got this straight or not.

Link [Edit: New diagram with normal LEDs]

Thanks in advance!


P.S.: The LEDs in the diagram are 2b in series, 1g & 1w FoC via the CE.