Page 2 of 2 FirstFirst 1 2
Results 11 to 11 of 11

Thread: NBv3 w/ 3-pin Quick Connect Wiring Check

  1. #11

    Default

    Done. Currently have a white super bright on the bottom and a blue super bright on the top, wired with the blade to give the same icy silver as the blade. The 3mm blue is mounted next to the bottom white. Pretty simple to rewire at this point. Might even have enough room to fit a 3mm blue in the top fitting, I want to re print the top of the chamber anyway. I did a print on my SLA in NEXT and the material is not holding the set screws the way I had hoped...should have listened to my own advice but the FDM printer was out of commission at the time and we needed it for the science fair presentations.
    Last edited by FenixFire; 06-07-2016 at 09:49 PM.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •