NBv3 with Recharge Port & PLI Wiring Confirmation

[Cha-Li Obedi]

Good day all,

I'm about to start wiring my first sabers with sound. I've got the 3.7v 18650 battery pack, Tri-Cree G-G-W with 3 x .5ohm 3w resistors for each LEC die, 2.1mm Switchcraft Recharge Port, PLI, 2w Bass Speaker & 16mm AV momentary switch with a 20mA DynaOhm variable resistor.

I think I have everything wired correctly; however, I would love if you guys could take a quick look and let me know if I'm on the right path or not.

Thanks so much everyone and MTFBWYA!
NBv3 Saber Wiring.jpg

[Greenie]

Looks good to me

[Cire Yeldarb]

looks right to me as well

[Cha-Li Obedi]

Thanks so much for the sanity check guys. Also, Greenie...I made sure to get at least three or four extra pieces of LED tape in case.

[Greenie]

Thanks so much for the sanity check guys. Also, Greenie...I made sure to get at least three or four extra pieces of LED tape in case.

LOL
Guess you've been doing some reading. I only offer that piece of advice cos I broke a joint first time and had to resolder with it already stuck to the heatsink. PITA!