-
Wiring a tri cree LED to Bladebuilders circuit
The board already flashed on clash, so could I just get a BBB option and join all the positives and negatives to two wires and connect those to where I would in a single side led? Obviously attaching reisitors to the LEDs before. Also, would a 3.7 volt battery be enough to power that?
-
-
I've looked at that one, yes. What im wondering is if I can run a single resistor to the positive wire after joining the three pads together and run that to the transistor set up. Also, would a 3.7 volt be enough to power the tri cree?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks