Sink tube Staff

[Bescherman]

I think that this is similar to what you are trying to describe:



I'm thinking of using this construction method to create my own glow staffs. Although I'll probably build a prototype out of MHS parts, I want to ultimately find a cheaper way to mass produce them and this could be a way to do it.

You'd need the correct diameter of pipe and then tap appropriate set scew holes into it (you could possibly countersink the screws if it bothered you).

I'm thinking of using a tube of sillicone on the outside for grip and to cover up any screws.

Does anyone have any input on this?

[darthdan]

I had thought of that actually, my only concern is that I like having the OD being 1-1/4". I have smaller hands and once you put grips on the outside of a 1.5" tube it gets a little large. With a 1-1/4 sink tube with an inner tube your ID gets a little small for batteries...