Hi everyone,
I'm really new to these forums. Mostly I've been lurking around and trying to soak up as much information as possible, but I have a question for all of you saber builders out there. Shown below is a very rough draft of a custom saber I would like and I would like to know if it would it be possible for me to make an emitter like this without the use of a lathe?
Scan.jpg
I'd also like the hilt to be machines down to accept the leather wrap so it doesn't protrude from the hilt and add bulk. I know I'm certainly going to get my hands on a Dremel with all the accessories, but I'm a little worried that method may not produce ideal results.
Any input or feedback is greatly appreciated!
Bookmarks