-
Nano Biscotte v2: board doesn't boot up after deep sleep
Hello
I build my first saber and have a problem with the deep sleep of my nano biscotte v2.
I wired a illuminated activation switch as show in the manuel (power indicator wiring, off during deep sleep, wired to the capacitor), the deep sleep timer in the config.txt is set to 5minutes.
The board enters the deep sleep mode after 5minutes, but the power indicator doesn't switch off.
Pushing the activation switch seems to do something, there is some noise coming from the speaker (like a silent coil whine with regular cracking noises in between) which isn't normally there when the board is powered but the blade retracted, but i can't activate the blade.
I have to cut the power (killkey), an then power the board back on again.
Besides that, everything works fine.
Anyone had a similar problem?
Greetings from Austria, Tom
Edit: i just found the "nano biscotte" sub forums, can someone please move this thread?
Last edited by TheMCP; 03-21-2016 at 05:18 AM.
-
Force Aware
-
Thanks a lot Don Se Wion, first solution worked for me!
Regards Tom
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks