hey everyone, so long story short I've been wanting to build my own lightsabers for a long time now, and now that my skills in wood working have become good enough I want to start to delve into this hobby. My intention is to build 3 lightsabers; Ahsoka Tano "Rebels" Sabers for myself and a Gungi Lightsaber to give my best friend as a best man request/gift. I've pasted a copy of the list of electronics for the three below. The biggest frustration I have is my lack of electrical knowledge which I've been trying hard to get better at through weeks of research.
So I really have three main questions, do the numbers look good in terms of Voltage/mAH? Do I have the correct amount of batteries per saber (4 Packs, 1Cell for Ahsoka) (3 Packs, 2 Cells Gungi) ? And my last question is how do I wire the extra batteries to power the Tri Rebel LEDs but not blowout the Nano BV3? I really appreciate any suggestions if anyone takes the time. Thanks guys!
3.4 to 5.5v (max) / 2A Nano Biscotte V3 (Qty 3), 28mm Speaker (qty 3), Battery for Board LI battery 3.7V 3400 mAH PCB Panasonic Li-Ion 18650 (qty 3), SPST Momentary Tactile Switch (qty 3), 2.1mm Power Jack (qty3)
Two Light Sabers- Ahsoka katana/shoto- Batteries for LEDs: (qty4) 7.4V LI-Ion 2600mAh 18650 Pack,(qty2) buckpuck 700 Max input 34V Min 5V
Cool white: Max Forward V9.75, Typical 8.7V, Max Drive 1000mA, Recommended 700mA
Blue: Max Forward V10.53 (FoC), Typical 8.5V, Max drive 1000MA, Recommended 700mA
26.4V Total Needed for LEDs?
One Light Saber- Gungi Purple- Batteries for LEDs: (qty 3) 7.4V Li-Ion 2600mAH 18650 Pack, (qty1) 3.7V 3400 mAH Panasonic 18650, (qty1) Buckpuck 700 Max input 34V Min 5V
Deep Red: Max Forward V8.4 Typical 6.3V Max Drive 700mA Recommended 700mA
Royal Blue: Max Forward V10.5 Typical 8.7 V Max Drive 1000mA Recommended 700mA
Cool white: Max Forward V9.75 (FoC) Typical 8.7V Max Drive 1000mA Recommended 700mA
24.1V Total Needed for LEDs ?
Bookmarks