-
CF 7 -maybe this is the issue
Hey all,
Basic Part Info
CF 7.0
7.4 v battery pack
GRBA tri cree
I had an operating set up for my cf but needed to shorten it to fit into hilt- When I finished I tried to fire it up but nothing- no boot or anything-The board is definitely getting power(used the meter) and I do get a "power to board indicator" to light but nothing else. I do not believe I did any solder work with the pack or sd inserted/attached.
I reformatted the sd card as suggested- Upon installation of said card, I did hear a boot sound but was not able to activate saber, or reproduce the boot sound there after. I was asked if I maybe had some solder beads drop on the board- i think i over looked this-IMG_0331.jpg
Would that cause my saber to stop functioning? Would that do damage to the board?
Any guidance is appreciated
Thanks,
Salohcin
-
a boot sound is definitely a good sign! but only getting it intermittantly implies something maybe loose or shorting. check those pads for bridges or bad joints. the one in your pic looks ok still, but i would reflow it with a tiny bit of new solder just to be sure. do the same for any other suspect joints.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks