Also I'm not having a recharge port, so between battery and sound board if I have enough wire
Also I'm not having a recharge port, so between battery and sound board if I have enough wire
Ok, this may be a dumb question, but I've never seen this in practice, are the PLIs functional or are they just for show with all the lights on.
Read the last paragraph in the description
http://www.thecustomsabershop.com/PL...ator-P267.aspx
So yes if I cut that lead?
They're always functional. That's why they have a huge chip on the back. You cut the lead to change the "mode".
From the store page:
It's a fully functional PLI. You can have a bar that fills up, or have a single LED showing the charge level.There are 10 LED's (5 green, 2 yellow, 3 red) which light up depending on battery voltage.
For 3.7V li-ion battery cell the LED's will all be off at 2.4V and all on at 3.7v
For 7.4V li-ion battery pack the LED's will all be off at 4.7V and all on at 7.3v
The PLI is setup for a single 3.7v Li-ion cell with all active LED's lit by default.
It can be used with a 7.4v Li-ion pack by bridging the two small solder pads on the backside as shown.
It can be setup to only show one LED at a time by cutting the chip lead as shown.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Thank you SS your description is most accurate to what I want
Bookmarks