I am currently working on a NB v3 lightsaber that I want to put FOC in. I haven't been able to find a straight answer on this: which resistor should I be using from the Px2 to the FOC LED?
I am currently working on a NB v3 lightsaber that I want to put FOC in. I haven't been able to find a straight answer on this: which resistor should I be using from the Px2 to the FOC LED?
Chris Harrison
CH Customs
You won't get a straight answer unless you provide the necessary information.
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law teaches you how to calculate your resistor values. The three pieces of information you need are: Source voltage (typically your battery pack voltage), the forward voltage of your LED, and the desired current you wish to give your LED (typically 1000mA or 700mA for high powered LEDs, 20mA for accent LEDs).
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
It should also be noted that the NBv3 has an on-board PEx and therefore has no need for an external one. Make sure you look at the manual for wiring diagrams.
Thank you. I didn't know that change from the NBv2
Chris Harrison
CH Customs
Bookmarks