Hi! Annyone knows how to dissambly the Kylo Ren Bladebuilders Electronic correctly? I have one and i want to modify it but... Its all glue it. The only part i can remove is were i can change the battery :C
http://www.youtube.com/watch?v=fl0kZEG-ahM
Hi! Annyone knows how to dissambly the Kylo Ren Bladebuilders Electronic correctly? I have one and i want to modify it but... Its all glue it. The only part i can remove is were i can change the battery :C
http://www.youtube.com/watch?v=fl0kZEG-ahM
Sharp razor knife, steady hands, and a lot of patience.
Or a Dremel.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
If you do it you should document it well, Im just waiting for my kid to break his so I can tear it open for the soundboard, haha.
I used a Dremel to cut off the top and bottom than cut down the middle. The board is located at the top of the hilt, right below the cross guards.
Bookmarks