So I goofed with my iron and burnt the pad off the board for the negative lead for the power switch. Is this board junk now? Is there a away I can still power it for sound?
Thanks
So I goofed with my iron and burnt the pad off the board for the negative lead for the power switch. Is this board junk now? Is there a away I can still power it for sound?
Thanks
Last edited by utlonghorns416; 01-30-2016 at 03:38 PM.
Umm...wow. I'm not sure if there are any alternate points to attach a switch wire. If not, that board is likely hosed.
Someone with more experience working with those boards will need to chime in.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Thats what I feared, time to start over.
Unfortunately, it looks like there is no fix, looks pretty burned off. Also, your wiring is incorrect. You need to be using a pnp transistor. I posted a diagram yesterday on here that might help you on your next board. Also, watch the length of the wires to your solder joints, they seem a bit long and may cause a short once you start cramming it all inside. One more tip, use a thinner solder.
http://forums.thecustomsabershop.com...ilders-diagram
Last edited by soundwave809; 02-05-2016 at 06:15 AM.
Thanks for the information, I was wiring it to a buckpuck 1000mah.
Bookmarks