Hello, TCSS forum members! I'm a complete novice to the art of saber-crafting, but I want to modify my current hilt to have full electronics (l.e.d., sound, aux. switch, the works). The problems I think I'm going to run into once I start completing my hilt are 1) the only piece that comes unscrewed is the pommel, and 2) around the switch section of my saber there is a quarter-inch thick inner ring that spans the entire switch section length on the inside, which is probably going to be a nightmare for installing switches. My hilt is a Saberforge (I know, I know) arbiter V2. It seems like a chassis system would fit if I made it as compact as possible, and I could probably use a screw of some kind to secure an l.e.d. module, but as far as getting it all in there, I'm a little stumped. Is anyone familiar with SF hilts and how to d.i.y. electronics install on them? I know it's a lot to ask, given SF's... popularity... but if anyone could help out, it would be very much appreciated! Thanks
Bookmarks