Graflex - MR soundboard - Tri Cree (G,R,RB) -

[x-4creator135]

Hello this is my first build and i need some help .
This is my list of what i have / ordered on the way :

LIST:

TCSS PARTS---

1 of: Graflex 2.0 Saber Kit
2 of: Premium 28mm Speaker
2 of: 2W 28mm Bass Speaker
10 of: 26 gauge wire (sold by the foot) (Yellow) 0.25 per foot
10 of: 26 gauge wire (sold by the foot) (Red)
10 of: 26 gauge wire (sold by the foot) (Purple)
10 of: 26 gauge wire (sold by the foot) (Orange)
10 of: 26 gauge wire (sold by the foot) (Grey)
10 of: 26 gauge wire (sold by the foot) (Green)
10 of: 26 gauge wire (sold by the foot) (Blue)
10 of: 26 gauge wire (sold by the foot) (Black)
5 of: Collimator Lens 8.7 deg viewing angle
1 of: Custom Tri-Cree LED ( G ,R,RB ) (saving for another project now)
1 of: CREE XP-E2 Blue *( for this project)
1 of: CREE XP-E2 Red (for battle damaged luke esb)
5 of: Star thermal tape pad
5 of: 2.7ohm 10w resistor
5 of: 4AAA Battery Holder with JST connector

5 of: Cree/Rebel Lens Holder

10 of: 1/16" Heatshrink tubing


2 of: MHS speaker mount V6 - For 28mm Speakers
2 of: 9" Electronics shield for 1.25" ID tubes <--- MAY NOT FIT


VADERS VAULT ----

1 x 7/8" Diameter Blade
(Blade Style: Standard clear, Blade Size: 34", Tip Type: Bullet, Tip Style: Mirrored)

1 x Blade Dust Caps



1 x D-Ring Belt Clip


------------------------------------------------------------------------------

7/8" Aluminum heat Sinks for Tri Led
Quantity: 2

----------------------
Saberforge ----
blade plug
Color: Silver/BlackLength:

--------------------------------------------------------------------------------------------------------------------------------

MASTER REPLICAS 2004 LUKE ESB SOUNDBOARD

MR STOCK CLASH AND MOTION SENSOR


So my plan is to add sound & light in a TCSS Graflex 2.0 kit, I have a master replicas Luke esb soundoard as well as the clash and motion sensor.
I ordered all of my electronics from TCSS and the accessories else where. I have some issues that need resolving and guidance, I need to know how to even wire my LED and Power supply.. the female connector is connected to the soundboard and im not sure how to get the JST male connecters on the battery pack to fit a 5 pin male connector. and the female connector is a 7 pin and so i dont know how to connect the tri cree to it im thinking there are adapters. but id like that answered if possible. or if i need to desolder it with the desoldering pump i ordered. i ordered a couple of each thing except for the LED. but i have 2 different kinds of speakers ( planning on using the bass for this build )

can anyone give me tips on what else i need for this build..
pictures below, your help is greatly appreciated


image1.jpg

image2.jpg

image3.jpg

image4.jpg

image5.jpg