NBv3 Problem
I am building a lightsaber with a NBv3 board. I made sure all of the wires were connected to the right pads. But when I attach the battery, it seems to bypass the switch and speaker. The led comes on, but I get no sound from the speaker and have no control from the switch. Any ideas on what I should do?
Chris Harrison
CH Customs
Sounds like you might've goofed on the wiring. We can better help you if you added pictures of your wiring and perhaps a wiring diagram that you used.
Doing so will make it easier for us to pinpoint your problem
Why did Isendra die? Tell me the truth!
That it is beyond your abilities does not mean it is beyond mine. I learned the lesson of Isendra's death. But I was given my power for a reason, and it is my burden to use it.
I will use it, not fear it as you do, High Councilor Valthek
On an unfortunate note, I just tested the board without the led attached, and all I get out of the speaker is a clicking noise
Chris Harrison
CH Customs
Howdy.Make sure you didn't solder your board with the SD card in. That's tops on the list. Make sure your battery is fully charged. Pull your SD card and format it, reload the sound fonts and give it a go. But the best possible way to get help is drop some pictures of the work here in the forums
After you've done that maybe there's a simple solution to your problem we can find.
Posting Permissions
Reply With Quote
Bookmarks