Results 1 to 5 of 5

Thread: Where is the swing sensor on this econo board?

  1. #1

    Default Where is the swing sensor on this econo board?

    Hi,

    I have dissasemble a bladebuilder Vador, and i want to upgrade to a double swing sensor but i have doubts about where is the original swing sensor ��image.jpg
    Last edited by wolf69; 02-01-2016 at 04:58 PM.

  2. #2

    Default

    Up please

    I know the green is the clash sensor, i assume the big black thing is the swing sensor but i dont understand why there are 3 legs/wires

  3. #3

    Default

    Following since Id like to upgrade mine.

  4. #4

    Default

    I'd have to agree that the big black sensor on the pad labelled "SW3" is very likely the motion sensor. It probably has three legs on it for one being a ground, and the other two being the positives for the ball bearing that is inside it to make contact with to achieve multiple swings. Again, just my guess.

    Got a question? Start Here. Have you tried the Thread Index yet? Most questions can be answered there.

  5. #5

    Default

    Thank you
    That's what i was thinking but i needed a second opinion

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •