-
Where is the swing sensor on this econo board?
Hi,
I have dissasemble a bladebuilder Vador, and i want to upgrade to a double swing sensor but i have doubts about where is the original swing sensor image.jpg
Last edited by wolf69; 02-01-2016 at 04:58 PM.
-
Up please
I know the green is the clash sensor, i assume the big black thing is the swing sensor but i dont understand why there are 3 legs/wires
-
Following since Id like to upgrade mine.
-
Council Member
Jedi Council Member
I'd have to agree that the big black sensor on the pad labelled "SW3" is very likely the motion sensor. It probably has three legs on it for one being a ground, and the other two being the positives for the ball bearing that is inside it to make contact with to achieve multiple swings. Again, just my guess.
-
Thank you
That's what i was thinking but i needed a second opinion
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks