Hey guys, been having a problem and wondering if anyone can help me out.
I'm wiring a 12W saberforge with a Nano Biscotte V2 board, for my tests I have it in the pictured configured. At first when I tried with a 12W diode, the board would shut off due to too much power draw from the diode (it would light up for half a second then turn off). So I was told to do a small hack with a power extender (the one from TCSS) in the pictured configuration. Yet I'm still having the same issue, so I'm wondering if anyone has any idea what it could be?
Also the picture is not the final circuit but just what I use for my tests. I start the board by shorting the Activator switch pad with the ground.
Bookmarks