Hello, I am putting together my first build with the Graflex 2.0 and I am figuring out which resistors I will need for the Cree Tri-XP-E2 RB/RB/W. I have done some research and used this LED calculator online. http://led.linear1.org/1led.wiz I just wanted to run the results by you seasoned veterans and seek some advice. I am hoping to obtain a NB V3 board powered by a 3.7 18650, I am using a 3d Printed chassis from Darth Ryo. With that said here are the specs.

Royal Blue Cree Part# XPEBRY-L1-0000-00Q01
600mW Minimum Radiant Flux @ 350mA
Forward Voltage @1000mA = 3.41v
Calculating = 1 ohms, 1/4W Resistor

And

White Cree Part# XPEBWT-L1-0000-00F51
266 Minimum Luminous Flux @ 1000mA
Forward Voltage @1000mA = 3.15v
Calculating = 1 ohms, 2W Resistor
Depending on if this is correct, I have seen the 1 Ohms,2W resistors, but for the 1 ohms, 1/4 W what would I use?

Thanks for any advice, sorry if its a silly noob question, I really am trying to do my due diligence so I dont have to bother everyone!

voodoo