After a year or so of lurking and reading and learning I've taken the plunge and ordered what I need for my first saber! I was actually ready to do it a few weeks ago but the Crystal Focus boards were out at the time but now they are back in stock so it's time to start!
This is my basic design:
Initial Saber Plan.jpg
I planning on adding some more bits once they get back in stock as well as doing some 3d printing / painting for detail work. I did the internal modeling to get my spacing, it's going to be tight but I think I can pull it off. If not I may have to make an extension for it, but only in the 1-1.5 inch range. I'll see once I do a mockup of the parts after they get in, I'm pretty handing with 3d modeling as well as metal lathe/millwork so coming up with a solution should be fun.
Also going to be in it:
CF 7.5
tri cree RGRB
7.4v 18500 pack
recharge port on the pommel
misc chassis parts
I'll post more pictures / plan once the parts start arriving!
- Bambua
Bookmarks