Results 1 to 3 of 3

Thread: Corbins Driver

  1. 12-25-2005, 09:59 AM #1
    phrstbrn
    phrstbrn is offline
    Join Date
    Dec 2005
    Posts
    1

    Default Corbins Driver

    I'm trying to plan for my saber. I was looking at Corbin's driver and I can't find anywhere that says what the input voltage is supposed to be. I understand that the driver uses up some power, but how much?

    Also, will the driver fit in the modular hilt system?

    Thanks in advance!
    Reply With Quote Reply With Quote
  2. 12-25-2005, 11:02 AM #2
    xwingband
    xwingband is offline
    Council Member
    Jedi Council Member     xwingband's Avatar
    Join Date
    Nov 2005
    Location
    The training simulators, duh!
    Posts
    5,899
    Send a message via AIM to xwingband Send a message via Yahoo to xwingband

    Default

    http://www.youcanknow.org/corbin/

    ^^^ Corbin's main site

    He has a wiring guide up. He recommends 4AA for a 1W LED and 5 for a 3W. The specs page also says it's 1 5/8 x 1 1/4 x 3/8 so I think that would fit in the modular sabers comfortably.[]

    <center>
    www.dewbackwing.com</center>
    Reply With Quote Reply With Quote
  3. 12-26-2005, 11:39 AM #3
    Strydur
    Strydur is offline
    Owner of the Custom Saber shop Strydur's Avatar
    Join Date
    Oct 2005
    Location
    USA
    Posts
    3,521

    Default

    They need to be lightly shaved on the side to fit but then it will be held in place good and tight.

    Tim
    The Custom Saber Shop
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules