Alright I am in need of assistance. It has been some time (years) since I have built a lightsaber and well a few months ago I felt the awakening and decided to build a new one. So down to business I have hilt parts from a previous saber and decided to save a few credits and use them so I ordered all my internals including an old style LED mount since my blade holders are the old style. So after I wire it together (that brought back some found memories) I go to screw the blade holder onto the choke that is holding my LED and once I get it screwed all the way down their is a gap between my lens and the blade holder it dose not sit flush. I tried using clocking washers to rase the LED mount up thinking that would make it sit flush but it still dose not sit flush. I have tried it with two other different blade holders and chokes but on each one it still is not flush. I am wondering if I just need to buy the new style blade holder and mount and that should work or what? Any suggestions would be greatly received.
Bookmarks