Running a staff on a single NB

[TenFootNine]

Hi everyone!

I would like to run a staff with 2 LED-modules on a single Nano Biscotti with an 18650.
Am I correct that the best way to do this is simply run the LEDs in parallel, so basically just splitting the positive and negative wires that go from the board to go to both LEDs?
I'm using single cree's for this one.

[Miraluka]

That's how I'd wire it if I were doing this.

[Cire Yeldarb]

Yup, that is what I would say.

[Obi1]

I would also do it like you proposed. I guess with 2 LEDs you are not crossing the 2A limitation, right?

[Miraluka]

I would also do it like you proposed. I guess with 2 LEDs you are not crossing the 2A limitation, right?

That just depends on how you're driving your LEDs. You could break 2A but you normally wouldn't.