Results 1 to 3 of 3

Thread: Wiring an RGB Tri Cree XPE 2

  1. #1

    Default Wiring an RGB Tri Cree XPE 2

    Hello everyone,

    I'm hoping for a little advice on what I'm doing for my build. I'm planning on doing a direct drive to the LED with my Prizm board and the 18650 protected battery from the shop. Even with the direct drive I'm still gonna want to crunch and re-crunch the numbers for my resistor value to the red diode on the LED aren't I? Would it be best to just resistor all three?

    Thanks for any help.

  2. #2

    Default

    You would need a resistor on all three anyway with a Prizm.
    TCSS MODERATOR
    All n00bs READ these first (PLEASE)!!!:
    1. Forum Guidelines
    2. FJK’s “Down and Dirty” guide to Ohm’s Law

    "Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
    My email: fjk_tcss@yahoo.com

  3. #3

    Default

    Makes sense. Thank you!
    Just a fan. If fans just make lightsabers that is.

    "I got a tale that's never been told, get to grips and handle your soul."

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •