Results 1 to 3 of 3

Thread: Can you drill a hole in a LED "Corbin style" blade?

  1. 09-24-2015, 02:13 PM #1
    seym56
    seym56 is offline
    Join Date
    Jul 2015
    Location
    use
    Posts
    32

    Default Can you drill a hole in a LED "Corbin style" blade?

    I am wondering if you could drill a hole in a LED "Corbin style" blade? Would it mess up your blade if you do this? I was thinking of doing this so I could secure the blade in a hidden holster when I don't have it in my saber. I would put the hole in the same location as where the thumb screw goes on the blade holder.

    Also, does anyone have any ideas for a blade holder that I could put together?
    Reply With Quote Reply With Quote
  2. 09-24-2015, 05:24 PM #2
    Silver Serpent
    Silver Serpent is offline
    Jedi Council Member Silver Serpent's Avatar
    Join Date
    Jul 2010
    Location
    USA
    Posts
    4,152

    Default

    You could, but it's not recommended. It would likely mess up the diffusion film inside the saber, not to mention weakening the blade at that point.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
    Reply With Quote Reply With Quote
  3. 09-25-2015, 08:55 AM #3
    seym56
    seym56 is offline
    Join Date
    Jul 2015
    Location
    use
    Posts
    32

    Default

    Thanks. I have thought of some better ways to to store the blade when not in use anyway.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules