Can you use a BuckPuck with a NB? Would you want to? I have just gotten all the parts for my saber build expect for the NB. Should I use a Buckpuck rather than resistors and if this is possible how would I do it(I would need a wire guide)
Can you use a BuckPuck with a NB? Would you want to? I have just gotten all the parts for my saber build expect for the NB. Should I use a Buckpuck rather than resistors and if this is possible how would I do it(I would need a wire guide)
No. The BuckPuck's minimum voltage is 5v, and the NB's maximum voltage is 5.5v. You'll either underpower the 'Puck, or cook your NB. Resistors are the way to go with the Nano.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
I think that's reversed. Puck Min is 5.5 and NB max is 5.
Darth Fender
Sith Lord
You over estimate my FLOWERS!
Thanks. That was what I was expecting but it is nice to have that confirmed. I will have my first saber completed by October so long as the NB stock holds out till my payday. It's the last part I need other than powder coating.
Hopefully, your payday is tomorrow.
Unfortunately it's a week from now. Worst case I'll just get a gift certificate and wait till they become available again. Shouldn't be to long a wait now.
Bookmarks