First Time Working With Sound. Need Help.
So as the title says this is my first time making a saber with sound. However, I have made a stunt saber before, so I know what I'm doing... sort of. Anyway, since I'm inexperienced with sound boards, I was wondering if I need to wire a resistor between my battery and my soundboard.
The soundboard I'm using is the PRIZM 3.5
And the battery I'm using is this one:
http://www.thecustomsabershop.com/Pa...tery-P853.aspx
Welcome to the Forums.
No, the resistor does not go there. If you look through the manual (located where you purchase the sound card), there are diagrams in there that explain exactly how to wire up the Prizm.
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Ok. So I just need resistors on the LEDs then?
Exactly.Originally Posted by Joby1kenobi
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Thanks! :) That was my original thought, but I wanted to triple check so I didn't just throw $100 down the drain.
Posting Permissions
Reply With Quote
Bookmarks