-
Machining the Emitter (with large image)
For the body of the lightsaber, I have an inner diameter of 1” (Will any battery packs fit in a 1” ID?) and an outer diameter of 1.5”. I’m going to use the 1” OD blade and all the wiring from this site. Below is a diagram of what I plan to make for the emitter. Is the 1/2" hole (in blue) too big? Will the led fall out? What are the dimensions for the led, collimator lens, and lens holder? Any help would be much appreciated; thanks.
Hooray for paint!
-
-
i'm going to use the lathe to cut it down. i just wanted some room to make a design on the hilt
-
will a 9v battery fit in the 1" ID of the hollow tube if i use a soft batter clip, or do i have to have a 1-1/8" ID?
-
-
the diagonal of a 9V is about 1-1/16". i think it will fit in 1-1/8" ID.
-
When you put the led, collimator lens, and lens holder all together, what is the greatest diameter?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks