-
Only reason i MENTION radioshack is because my local one is still up and running for the moment.
-
I think I'll be going with your option.
Which resistors would you recommend work best, and for which sides?
-
Jedi Padawan
Sith Adept
Jedi Padawan
The resistor you choose for the Red die will depend on your battery setup (sorry if you posted it already and I overlooked that detail). You can use FJK's post about Ohm's law to figure out the resistor value or use the calculator in SS's signature.
For the Pot, I can't say exactly what you'll need either. Personally, I popped over to the Fry's Electronics by my work and got a Pot with a range of 0-1k ohms (simply for the reason that all of the other ones they had had even higher maximum resistance values, and for what I was doing, even the 1k maximum was unnecessary). I wired it up in-line with my LED and, starting at 0 ohms, worked the resistance up until I was happy with the color that had been mixed. If you have a volt meter, you can then just measure the resistance of the Pot and replace it with a comparable resistor once you know the ohm value you would need, but that is not necessary.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks