-
Kylo Ren/Crossguard saber
What did anybody use for the crossguard blades?
-
Youngling
I have only seen one done and the builder custom machined the emitter from a blank blade holder (like you can find on here), attached two more blade holders, and cut short sections of regular blade material (6 inches or so) for the cross guard blades. You would need to run 3 single rebels to do this, and there would be A LOT of custom work involved getting it all to work out. If you haven't built a saber before (not saying you haven't), I would highly recommend starting with something simple. Theres a ton of work that goes into building a single bladed saber even when you dont have to do ANY custom machining.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks