20150506_213149.jpg20150506_213204.jpgoh yeah, drilled and tapped you're looking at about 1/8" to 3/16'" on each side... the bezel wall is 1/16" thick so use that as the reference size.
**EDIT** its a lot closer to 1/8" on each side than 3/16"
20150506_213149.jpg20150506_213204.jpgoh yeah, drilled and tapped you're looking at about 1/8" to 3/16'" on each side... the bezel wall is 1/16" thick so use that as the reference size.
**EDIT** its a lot closer to 1/8" on each side than 3/16"
Last edited by cakira21; 05-06-2015 at 08:03 PM.
Amazeballs. Absolutely stellar. Thanks again Cakira.
I did a similar things using a piece of PVC on my first build. I needed clearance for the switches and this was the most economical solution I could find. It doesn't look as good as yours, but it works.2015507102856.jpg2015507102927.jpg
Bookmarks