Just in need of a look-over!

[daaguilar]

I don't even know how long I just spent sifting through the forums, trying to figure this out. I still feel like something is wrong with it. Any help is greatly appreciated!

[Thalan the Exiled]

If that is a dyna ohm going go the switch it needs to be on the positive I believe but other than that it looks good. That is exactly how I have my saber set up except I used resistors

[daaguilar]

Yeah that's the dyna ohm. You have your saber set up with the 4 AAAs and the Tri-Cree with resistors? If so, how is the life/brightness with that setup? I know the buckpuck is supposed to give you even brightness throughout the battery life but is it that much of a noticeable difference in brightness towards the end of the battery life?
And ok, so this is right?

[Thalan the Exiled]

Life is ok. I switched to 7.4v pack just to get better life. Tbe brightness was very consistant. And yes that looks right.

[daaguilar]

Gotcha. Well thanks so much. I really appreciate your help!

[Don Se Wion]

Actually you need to move the Dyna-Ohm, placed between the battery and the switch won't last very much.
This way I think it will be fried by the current drawn from the blade LED.

Just move it on the wire between NO1 and LED+ pads and you are just fine.

[Thalan the Exiled]

Yes I'm sorry he is right. . Wasnt thinking..getting old here. Lol

[daaguilar]

Thank you guys so much.
And no worries, Thalan, your input is still very appreciated!