Need help wiring momentary switch

[Molina00]

Sorry for the newbish question, but I haven't found anything that helps me.

I am trying to wire an illuminated AV switch, something I haven't done before. I did connect the DynaOhm resistor to the positive post but I don't know if I am supposed to use just two posts or all 4. I couldn't find a diagram that explained it.

I am working on an NB board with recharge port.

Any help would be great. Thanks.

[Thalan the Exiled]

It should have 2 posts labled with a + and a -. Those are for the illuminated ring/dot. The others should be labled c and I think no. Those are for the switch. So wire the accent led wires from the board to the +/- and the switch wires to the others. At least that is how I wired mine without a sound board.

[Evilpancreas]

Thalan is correct on the wiring. The switch's + and - to the accent LED spot, the other two (doesn't matter which lead) are just wired into the switch spots like normal. Just make 100% sure the dynaohm resistor is on the positive lead from the LED in the switch.

[Molina00]

Thanks guys, and sorry for the total newb question. I got it all wired up and working great.
Just need the chargers to get back in stock so I can make sure that part works..